Special-shaped stone grinding and polishing

Dysmorphism photometric sheet processing and the common difference is obvious, usually on the big board polishing directly of large manual polishing machine, polishing machine, or a little bit small each a special-shaped stone because of its shape, so polishing is more difficult than ordinary plate, just share with you below small make up of special-shaped stone polishing process
1, check the modelling of product shape is in accordance with the production process the shape of a single, qualified rear can into fine polishing process
2, grinding polishing before according to the condition of material to the plastic processing, plastic handle after grinding polishing;
3, first single line drawing coarse grinding, coarse grinding to keep 0.5 MM when the fine grinding, grinding allowance;
4, will be fine polishing lines according to the installation drawing together again, and according to the line color selection and preparation of the surface, to ensure the color, decorative pattern, good results. Line 1 # 500 first uniform number, according to the requirement of the installation drawing after polishing again apart, do not cause the fine polishing line on interfaces is concave and convex shape;
5, interface dislocation, the polishing of transition section distance should be stretched, as long as possible, and guiding rule shall be used to check a straight line when grinding degree;
6, complete grinding polishing lines from the quality inspection qualified rear can shipment;
7, special crafts grinding polishing to improve luminosity, reduce wave trick:
8, choose good grinding polishing materials;
 9, grinding polishing, each abrasive or after grinding fine polishing should be inspected carefully see smooth grinding polishing, after a after grinding, grinding should be produced during the cover off before a abrasive fingerprints;
10, grinding polishing, should pay attention to the control of water, water shortage of the burn see smooth surface;
11, grinding polishing along the line direction of plain wire stretched as far as possible, as long as possible, so that we can avoid moire.
12, faster when polishing;
13, using high speed grinding polishing power tools;
14, processing fine polishing the best mass line cutter, doing so can reduce the workload of coarse grinding, and ensure that the quality of the line after coarse grinding, shape, the consistency of the good.